E-14
BASS PIANO
PERCUSSION (No.99)
• PERCUSSION (Tone 99) assigns 35 percussion sounds to
the keyboard as shown below. The sounds assigned to each
key are indicated above the keyboard.
NOTE
• Always enter two digits for the tone number. If you enter only
one digit, the display will automatically return to the previous
tone number setting after a few seconds.
• If you change the tone setting while a keyboard key is
depressed, the tone does not change until you release the key
and press a keyboard key again.
• With certain tones (such as percussion sounds and sound
effects), there may be very little or no change at all in the pitch,
no matter which keyboard key you press.
• If you input the wrong first digit for a tone number, you can
return to the previous setting by pressing the TONE button.
Keyboard split tones
Some of the preset tones split the keyboard and assign two
or more sounds. With such a preset tone, the sound produced
depends on what position of the keyboard you play. For
example, BASS/PIANO (tone 90) puts BASS on the left and
PIANO on the right of the keyboard.
<Example>
BASS/PIANO (No.90)
Basic Operations
This part of the manual provides you with the basic
information you need to use your keyboard.
To switch power on and off
1.
Set the POWER/MODE selector to NORMAL.
2.
Press the keyboard keys.
3.
Use the VOLUME slider to set the volume to a
relatively low level.
4.
To switch power off, set the POWER/MODE
selector to OFF position.
To change tones
1.
Find the tone you want to use in the “Tone List”
(page A-1) and note its tone number.
2.
Press the TONE button.
3.
Use the number buttons to input the 2-digit
number that identifies the tone you want to
select.
Example: To select “26 ACOUSTIC BASS”, input 2 and
then 6.
GrandPno
Indicator appears
Aco . Bass
POWER/MODE DEMO
VOLUME TEMPO/VALUE RHYTHM
TONE
Number buttons
START/STOP
SYNCHRO/FILL-IN SONG BANK
To Next Page
Loading...
Need help?
General
