Measuring Elapsed Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
3. Press (A) to reset the measurement time
to all zeros.
Measuring a Split Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
●
If a lap time measurement operation is
displayed, clear it before proceeding to
step 2.
l
Measuring Lap Times
2. Press (A) to display [SPL].
●
Each press of (A) toggles between
[SPL] (split time) and [LAP] (lap time).
3. Use the operations below to measure
elapsed time.
●
Pressing (A) displays the elapsed time
up to that point (split time), alternating
with [SPL] for about eight seconds.
4. Press (A) to reset the measurement time
to all zeros.
Measuring Lap Times
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
●
If a split time measurement operation is
displayed, clear it before proceeding to
step 2.
l
Measuring a Split Time
2. Press (A) to display [LAP].
●
Each press of (A) toggles between
[SPL] (split time) and [LAP] (lap time).
3. Use the operations below to measure
elapsed time.
●
Each time you press (A), the watch
displays the time elapsed (lap time)
since the last lap time operation,
alternating with the stopwatch number
for about eight seconds.
4. Press (A) to reset the measurement time
to all zeros.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
●
The beeper is muted when battery power is
low.
Using CASIO WATCHES to
Configure Timer Settings
If the watch is paired with a phone, you can
also use the CASIO WATCHES phone app to
set the timer start time.
l
Configuring Watch Settings
Watch Operation Guide 5659
20
To Next Page
Loading...
Need help?
General