Casio XJ-V1 Setup Guide

FCC Information
This device, Wireless LAN USB Adapter, complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received; including interference that may cause undesired operation.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Tested to comply with FCC standard. FOR HOME OR OFFICE USE.
FCC RF Radiation Exposure Statement:
The Wireless LAN USB Adapter has been tested to the FCC exposure requirements (Specific Absorption
Rate).
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the
equipment.
1. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment,
under 47 CFR 2.1093 paragraph (d)(2).
2. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
XJ-V1
FOR CALIFORNIA USA ONLY
Perchlorate Material – special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate.

Casio XJ-V1 Specifications

General

Matrix size	0.55 \
Number of colors	1.073 billion colors
Native aspect ratio	-
Projection distance	- m
Projection technology	DLP
Contrast ratio (dynamic)	20000:1
Screen size compatibility	30 - 300 \
Projector native resolution	XGA (1024x768)
Keystone correction, vertical	-30 -30 °
Focus	Manual
Offset	72 %
Throw ratio	1.54 - 1.71:1
Optical zoom	1.1 x
Focal length range	- mm
Light source type	Laser/LED hybrid
Service life of light source	20000 h
Full HD	No
Supported graphics resolutions	1200 x 1600, 1680 x 1056
AC (power) in	Yes
Composite video in	0
USB connector type	Micro-USB B
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Noise level	37 dB
Noise level (economic mode)	35 dB
Placement	Desktop
Product type	Standard throw projector
Product color	White
Power source	AC
Power consumption (standby)	0.23 W
Power consumption (typical)	150 W
Operating temperature (T-T)	5 - 35 °C
Remote control type	IR

Weight and Dimensions

Width	270 mm
Height	89 mm
Weight	2800 g