CDA WC430 User Manual

Installation
• Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary.
• Only use the water inlet supplied with the appliance.
• If the water pressure is above 10 bar, a pressure relief valve should be used.
• After connecting the water supply, check to ensure there are no leaks.
• The water outlet can either be connected to a water drain or to a sink outlet
spigot. This connection should be at a minimum of 50 cm and a maximum
of 110 cm from the oor. The drain hose should be no longer than 4m in
length to ensure good performance from the dishwasher.
fig 14
fig 15
fig 16
fig. 11
fig. 13
40cm
100cm
14
WC430 Manual.indd 15 3/6/09 11:19:11

CDA WC430 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Quick wash	Yes
Washing class	A
Noise level	52 dB
Number of place settings	9 place settings
Number of washing programs	6
Water consumption per cycle	14 L
Energy consumption per cycle	0.8 kWh

Weight and Dimensions

Depth	550 mm
Width	446 mm
Height	820 mm