10
Changing a programme
It is possible to change the programme if necessary once the
programme has started.
• First open the door slightly to reduce the risk of water spillage.
• Press the ‘Programme selection’ button until the required
programme is shown on the display.
• Then close the door. The dishwasher will begin the new programme
from the point at which the old programme stopped.
Cancelling a programme
It is possible to cancel the programme once the programme has
started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold the ‘Programme selection’ button for approximately
three seconds, until the end of ‘Programme Indicator’ light flashes
and a ‘1’ shows on the display.
• Then close the door. The dishwasher will drain for approximately
thirty seconds. Once this is complete, the dishwasher will beep five
times and the ‘End of programme’ indicator light will switch on.
Switching the dishwasher o
• Once the dishwasher beeps five times, and the ‘End of programme’
indicator light switches on, the dishwasher can be switched o by
pressing the ‘Power’ button.
• Then, turn o the water tap and remove the plug from the power
socket.
Please note: The dishwasher will automatically continue on the
programme it has started if operation is interrupted.
To Next Page
Loading...
Need help?
General
