CEM DT-337 User Manual

11
Data Hold
To freeze the LCD meter reading, press the data hold
button. The data hold button is located on the left side of the
meter (top button). While data hold is active, the HOLD
display icon appears on the LCD. Press the data hold button
again to return to normal operation.
Note: The HOLD feature will activate when the Backlight is
turned on. Press the HOLD key again to exit Hold.
Backlight
Press and hold the HOLD key for >1 second to turn
on or off the display backlight function.
Note: The HOLD feature will activate when the Backlight is
turned on. Press the HOLD key again to exit Hold.
ZERO BUTTON
For ACA and Capacitance Zero & Offset adjustment.
Manual Ranging
The meter turns on in the autoranging mode. Press the
Range button to go to manual ranging. Each press of the
range button will step to the next range as indicated by the
units and decimal point location. Press and hold the Range
button for two seconds to return to autoranging. Manual
ranging does not function in the AC Current , Diode and
Continuity check functions
Battery Replacement
1. Remove the one rear Phillips head screw
2. Open the battery compartment
3. Replace the Requires two “AAA” batteries (UM4 R03)

CEM DT-337 Specifications

General

Brand	CEM
Model	DT-337
Category	Measuring Instruments
Language	English