HELPLINE NO 08448012949
13
ORIGINAL INSTRUCTIONS
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation
slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
qualied persons in order to avoid a hazard.
TROUBLESHOOTING
1. If your router will not operate, check the power
at the mains plug.
2. If a fault cannot be rectied, return the drill to
an authorized dealer for repair.
PLUG REPLACEMENT (UK &
IRELAND ONLY)
Your power tool is supplied with a tted plug,
however if you need to t a new plug follow the
instruction below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue = Neutral Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows. The wire which is coloured
blue must be connected to the terminal which
is marked with N. The wire which is coloured
brown must be connected to the terminal which is
marked with L.
WARNING:
Never connect live or neutral wires to the
earth terminal of the plug. Only t an approved
BS1363/A plug and the correct rated fuse.
Note: If a moulded plug is tted and has to be
removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
To Next Page
Loading...
Need help?
General