A-4 521969D1 K Rev
SAFETY
SAFETY SIGNS
m
WARNING: DO NOT remove or obscure
safety signs. Replace any safety signs that
are not readable or are missing.
Replacement signs are available from your
dealer in the event of loss or damage. The
actual location of the safety signs is
illustrated at the end of this section.
If a used machine has been purchased, make sure all
safety signs are in the correct location and can be read.
See Safety Sign Location of this section for illustrations.
Replace any safety signs that can not be read or are
missing. Replacement safety signs are available from
your dealer.
SAFETY SIGN LOCATION
General
The following safety signs are installed to alert operators
to hazards in specific machine areas. The signs are for
personal safety. READ AND UNDERSTAND THE
SIGNS!
Keep signs clean by wiping off regularly. Use a cleaning
solution if necessary.
Replace signs if missing, damaged or painted.
If a used machine has been purchased, make sure that
all the safety signs are in the correct place and are
readable.
Clean machine surface thoroughly with a cleaning
solution before replacing signs.
IMPORTANT SAFETY INFORMATION
Most personal injuries occurring during machine
operation, maintenance or repair are caused by failure to
observe basic safety rules and precautions. In most
cases, an injury can be avoided by recognizing
hazardous situations before an injury occurs.
Operator must be alert to potential hazards and have the
necessary training, skills and tools to perform these
functions properly.
Improper operation, lubrication, maintenance or repair of
this machine can be hazardous and could result in injury
or death.
Do not operate or perform any lubrication, maintenance
or repair on this machine, until reading and understanding
operation, lubrication, maintenance and repair
information.
Safety precautions and warnings are provided in this
manual and on machine. If these hazard warnings are not
heeded, bodily injury or death could occur to operator or
bystanders.
Not every possible circumstance involving a potential
hazard can be anticipated. The warnings in this
publication and on machine are not all inclusive. If using
tool procedure, work method or operating technique not
specifically recommended, be satisfied it is safe.
Make sure machine will not be damaged or be made
unsafe by operation, lubrication, maintenance or repair
procedures chosen. Information, specifications, and
illustrations in this publication are based on information
available at the time of publication.
Specifications, torques, pressures, measurements,
adjustments, illustrations, and other items can change at
any time. These changes can affect the service given to
machine. Obtain complete and most current information
before starting any job. Dealers have the most current
information available.
m
WARNING: When replacement parts are
required for this machine AGCO
recommends using AGCO replacement
parts or parts with equivalent
specifications including, but not limited to,
physical dimensions, type, strength and
material. Failure to heed this warning can
lead to premature failures, machine
damage, personal injury or death.
Find manuals at https://best-manuals.com
To Next Page
Loading...
Need help?
General
