521969D1 K Rev A-7
SAFETY
Engine Starting
Move all hydraulic controls to hold position before starting
engine.
Make sure transmission control lever is in park position.
Diesel engine exhaust contains products of combustion
which can be harmful. Always run engine in a well
ventilated area. If in an enclosed area, vent exhaust to
outside.
m
WARNING: Machine WILL turn if steering
wheel is moved when transmission control
lever is in NEUTRAL or PARK and engine is
running.
Do not start engine until area is free of personnel to avoid
personal injury due to unexpected machine movement.
Before Operation
Clear all personnel from machine and area.
Clear all obstacles from machine's path. Beware of
hazards (wires, ditches, etc).
Be sure all windows are clean and secured in shut
position.
Adjust rearview mirrors for best visibility close to machine.
Make sure horn, backup alarm (if equipped) and all other
warning devices are working properly.
On drawbar-towed implements, attach a transport chain
of sufficient capacity between machine drawbar support
and implement. Provide only enough slack in chain to
permit turning.
Fasten seat belt securely, low around hips. Only one
passenger/instructor should be allowed to ride in machine
cab, and must be seated in instructor seat and have seat
belt fastened.
Operation
Only operate machine while in operator's seat. Seat belt
must be fastened while operating machine. Only operate
controls while engine is running.
Check for proper operation of all controls and protective
devices while operating machine slowly in an open area.
Make sure no one will be endangered before moving
machine.
Report any damage noted during operation of machine.
Make any necessary repairs.
Hold attachments approximately 40 cm (16 in) above
ground level while driving machine. Do not drive machine
near an overhang, near edge of a cliff, or near edge of an
excavation.
If machine begins to sideslip on a grade, immediately
dispose of load and turn machine downhill.
Be careful to avoid any ground condition which could
cause machine to tip.
A rollover of machine can occur when working on hills,
banks, or slopes. A rollover of machine can also occur
when crossing ditches, ridges, or other unexpected
obstacles.
When possible, operate machine up slopes and down
slopes. Avoid operating machine across slope, when
possible.
Keep machine under control. Do not overload machine
beyond capacity.
Make sure towing devices are adequate for application.
Make sure components on three-point hitch are adequate
for application.
Connect trailing equipment only to a drawbar or hitch.
Never straddle, or allow other personnel, to straddle a
wire cable.
When maneuvering to connect equipment, make sure no
personnel are between machine and trailing equipment.
Block up hitch of trailing equipment to align equipment
with drawbar.
Know maximum dimensions of machine.
When operating on icy roads, reduce travel speed.
After operating in muddy conditions, allow sufficient time
for belts to reject debris and moisture before making high
speed maneuvers. Belts that are wet and belts that are
muddy may impede machine's steering.
If stability of machine is noticeably reduced, reduce travel
speed.
Select a gear that controls machine speed when
descending a hill.
Downshift if braking is required to control machine speed.
Never coast down a hill with transmission in neutral.
Do not steer machine when you cross ditches. Ditches
that are wide and/or ditches that are deep may allow
guide blocks to sag below midwheels. This can cause belt
to come off.
Do not allow passengers anywhere on machine except
on an approved passenger seat. Passengers must have
passenger seatbelt securely fastened during any
operation.
To Next Page
Loading...
Need help?
General
