79033095 C Rev. 1-1
Introduction
INTRODUCTION
SERVICE MANUAL
This service manual has been prepared with the latest
service information available at publication. Read and
understand service manual carefully before doing any
service on machine.
Right-hand and left-hand, as used in this manual, is
determined by facing direction the machine travels when
in use.
Photos, illustrations and data used were current at time of
printing, due to possible production changes machine
may vary slightly. Manufacturer reserves right to redesign
and change machine as necessary without notification.
m
WARNING: Some pictures in manual show
shields removed to allow a clearer view.
Never operate machine with any shields
removed.
Divisions and Page Numbers
Service manual is separated into divisions. Refer to
Master Table of Contents.
Each division has an identifying part number with an
alpha revision level indicator. Each division also has a
Table of Contents, Safety section and Index.
Each page is identified with division part number and
revision level. Pages are in numeric order within each
division.
UNITS OF MEASUREMENT
Measurements are given in metric units followed by
equivalent in U.S. units. Hardware sizes are given in
millimeters for metric hardware and inches for U.S.
hardware.
REPLACEMENT PARTS
To receive prompt efficient service, always remember to
have correct part number and description along with
model and serial number of machine.
Find manuals at http://best-manuals.com/search?&s=CHAL-79033095
To Next Page
Loading...
Need help?
General
