• Activate hazard warning flasher.
• Block both the front and back
of the wheel diagonally opposite
the jack position.
Remove
hubcap
or
wheel cover
with flat end of wheel
nut
wrench
and loosen wheel nuts slightly.
Set
lever on jack to
UP
position.
Properly position load rest which
engages bumper by moving base of
NOTE: Base of jack column
should be slightly angled in toward
car since it will straighteri
as
car
is
raised.
jack slightly under car and engage
tang of
bracket in bumper notch,
then bring jack base back toward
upright position. Check that
l~ad
rest
is
positioned before operatmg
jack.
40
Jack Operation
After jack
is
positioned
as
noted
above use
wheel nut wrench
as
. ,
jack handle and raise car until tire
clears ground. Remove wheel nuts
and wheel, install spare and tighten
wheel nuts. Move jack lever to
DOWN
and
install
hub
cap
or
wheel cover.
To Next Page
Loading...
Need help?
General
