yellowblue
2-18
Arming the System
Use one of the following items listed here to arm
the system:
D
Press the LOCK button on the key fob transmitter,
D
Walk out of range with the passive switch on, or
D
Open the door. (The SECURITY light should flash.)
Lock the door with the power door lock switch. The
SECURITY light will stop flashing and stay on.
Close the door. The SECURITY light should go off.
Testing the Alarm
Use the following to test the system:
1. Make sure the hatch/trunk lid is latched and set the
passive switch on the key fob transmitter to OFF.
2. Lower a window on the door.
3. Manually arm the system.
4. Close the doors and wait 15 seconds.
5. Reach through the open window and unlock the
door. Now open the door. The alarm should sound.
6. Turn off the alarm.
If the alarm is inoperative, check to see if the horn
works. If not, check the horn fuse. See “Fuses and
Circuit Breakers” in the Index. If the horn works, but the
alarm doesn’t go off, see your dealer.
Disarming the System
Always use your key or the key fob transmitter to
unlock a door. Unlocking a door any other way will set
off the alarm. If your alarm sounds, listed below are the
ways you can disarm it:
D
Unlock any door with your key.
D
Put the key in the ignition.
D
Press the UNLOCK button on the key
fob transmitter.
D
Walk into range with the passive switch on.
To Next Page
Need help?
General
