2-40
Turn Signal/Multifunction Lever
The multifunction lever on the left side of the steering
column includes your:
D
Turn Signal and Lane Change Control
D
Headlamp High/Low-Beam Changer
D
Cruise Control
D
Headlamps Switch
D
Flash
-to-Pass Feature
Turn and Lane Change Signals
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To signal a turn, move the multifunction lever all the
way up or down. When the turn is finished, the lever
will return automatically.
An arrow on the
instrument panel cluster
will flash in the direction
of the turn or lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return by
itself when you release it.
If you signal a turn or a lane change and the arrows flash
faster than normal, a signal bulb may be burned out.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows don’t go on at all when you
signal a turn, check the fuses and check for burned
-out
bulbs. (See “Fuses and Circuit Breakers” in the Index.)
To Next Page
Loading...
Need help?
General
