6-37
Rear Combination Lamps
The combination lamp assembly includes the
taillamp/stoplamp, turn signal and sidemarker bulbs.
A. Back-Up Lamps
B. Turn Signal Lamps
C. Taillamp/Stoplamp
D. Rear Sidemarker
To replace any of the rear combination lamps:
1. Open the trunk.
2. Remove the three plastic screws located on the
access panel.
3. Pull back the access panel.
4. Turn the bulb socket counterclockwise and pull
it out.
5. To remove the turn signal or tail/stop lamps, turn
the bulb socket in, to remove it from the housing.
Then push in and turn the bulb counterclockwise.
6. To remove the sidemarker socket, turn it
counterclockwise to remove the housing.
Then pull the bulb straight out from the socket.
7. Reverse the steps to install a new bulb.
To Next Page
Loading...
Need help?
General
