6. Install the new bulb into the socket by pressing it in
and turning it clockwise.
7. Install the socket into the lamp housing by turning it
clockwise.
8. Reverse Steps 1 through 2 under Headlamps
(Hatchback) on page 5-41 or Headlamps (Sedan)
on page 5-42 to install the assembly.
Turn Signal Lamps (Side)
To replace a side turn signal bulb:
1. Open the hood. See Hood Release on page 5-10
for more information.
2. See Steps 2 through 5 under Headlamps
(Hatchback) on page 5-41 or Headlamps (Sedan)
on page 5-42 to access the side turn signal lamps.
3. Remove the side turn signal lamp assembly
by pulling it forward.
4. Turn the bulb socket counterclockwise.
5. Remove the bulb from the lamp housing by pulling
the bulb straight out of the socket.
6. Install the new bulb into the bulb socket by pushing
it in and rotating the bulb socket clockwise.
7. Push the side turn signal lamp assembly back into
its original position.
5-45
To Next Page
Loading...
Need help?
General
