The STABILITRAK NOT READY message may be
displayed in the DIC and the traction control system and
StabiliTrak
®
warning light on the instrument panel
cluster will be on after first driving the vehicle and
exceeding 30 mph 48 (km/h) for 30 seconds. The
StabiliTrak
®
system is off until the light has turned off.
This could take up to 15 minutes. See DIC Warnings
and Messages on page 3-49 for more information.
The traction control system and StabiliTrak
®
warning
light on the instrument panel cluster will flash when the
system is operating. You may also feel or hear the
system working. This is normal. This light may also
come on after extended heavy braking indicating the
brakes have become too hot to limit wheel spin.
StabiliTrak
®
can be turned off using the traction control
button. To disable StabiliTrak
®
, press and hold the
traction control button for five seconds. StabiliTrak
®
can
be activated again by pressing the traction control
button.
The SERVICE STABILITRAK message will be displayed
and the traction control system and StabiliTrak
®
warning light on the instrument panel cluster will come
on if there is a problem with the system. When this light
and the SERVICE STABILITRAK message are on, the
system is not operational. Adjust your driving accordingly.
All-Wheel Drive (AWD) System
If your vehicle has all-wheel drive (AWD), the AWD
system operates automatically without any action
required by the driver. If the front drive wheels begin to
slip, the rear wheels will automatically begin to drive
the vehicle as required. Torque is also applied to the
rear wheels during launches. There may be a slight
engagement noise during hard use but this is normal.
This light is located on the
instrument panel cluster.
This light and the SERVICE ALL WHEEL DRIVE
message in the DIC will come on and stay on to indicate
there may be a problem with the drive system and
service is required.
4-8
To Next Page
Loading...
Need help?
General
