You can install external modules before or after mounting a router. However, if you choose to install the
external modules after mounting the router on the rack or wall, ensure that you have optimal access to the
back/front panel of the router.
For information on modules and Field Replaceable Units (FRUs), see the Install and Upgrade Modules and
FRUs section.
Note
Depending on the model, the available options for mounting a Cisco 1100 ISR are:
Table 1: Models and Mounting Options
Mounting OptionsModel
Desktop, Rack Mount, Wall Mount using Key-hole Slots, Wall Mount
using-Din-Rail
C111x and C1111X
Desktop, Wall Mount using Key-hole SlotsC1101-4P
Desktop, Wall Mount using Key-Hole SlotsC1101-4PLTEPWx
Desktop, Wall Mount using Key-Hole Slots,C1109-2PLTExx
Desktop, Wall Mount using Key-Hole SlotsC1109-4PLTEPWx
Desktop, Wall Mount using Key-Hole SlotsC1109-4PLTEPWx
Desktop, Wall Mount using Key-Hole SlotsC1109-4PLTEPWx
Desktop, Wall Mount using Key-Hole SlotsC1109-4PLTEPWx
Desktop, Wall Mount using Key-Hole SlotsC1109-4PLTEPWx
Desktop, Rack Mounting using Din-Rail Brackets, Under DeskC1121-4Px
Desktop, Rack Mounting using Din-Rail Brackets, Under DeskC1126(X)-8PLTEP
Desktop, Rack Mounting using Din-Rail Brackets, Under DeskC1128(X)-8PLTEP
If you choose to setup the router on a desktop, you can place the router on a desktop, bench top or on a shelf.
Rack Mount
The router is shipped with rack mounting brackets that are to be secured on the sides of the chassis. You must
first secure rack mounting brackets on the chassis before you set up the chassis on the rack.
Do not stack multiple Cisco 1000 ISRs when mounting the routers on a table top.
Caution
Install and Connect the Router
2
Install and Connect the Router
Rack Mount
To Next Page
Loading...
Need help?
General
