3
Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers
OL-3317-03
Related Documents
Figure 4 ADSL over POTS with Dying Gasp WIC
Figure 5 ADSL over ISDN with Dying Gasp WIC
Memory Requirements
The memory requirements for running the full-featured Cisco 1700 router encryption images with the
ADSL WICs are as follows:
• 16 MB of Flash memory
• 64 MB of dynamic RAM (DRAM)
Related Documents
The following documents provide additional information about installing and configuring ADSL WICs
and configuring the router software:
• Cisco WAN Interface Cards Hardware Installation Guide—provides installation information on the
ADSL WAN interface card.
• Regulatory Compliance and Safety Information document—provides safety warnings and
compliance information for your router.
• Cisco 827 Routers Software Configuration Guide—provides router configurations for ATM data and
voice networks for the Cisco 827-4V router. These configurations will also work for the Cisco 1720,
1721, 1751, and 1760 routers, except for the dialer interface.
• Cisco IOS configuration guides and command references—provides IOS commands and
configurations for your router.
The following document provides additional information about configuring QoS features and Frame
Relay Forum (FRF) internetworking functions on ADSL WICs.
• Enhanced Voice and QoS for ADSL and G.SHDSL on Cisco 1700 Series, Cisco 2600 Series, and
Cisco 3600 Series Routers
FCC Notice
The following FCC Notice applies to the Cisco 1700 series ADSL WIC:
WIC-1ADSL complies with FCC part 68 FCC ID:5B1USA-42011-DL-N
WIC
1ADSL DG
ADSL
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
88862
WIC
1ADSL IDG
ADSL
SEE MANUAL
BEFORE INSTALLATION
CD LP OK
88863
To Next Page
Need help?
General
