Cisco 1700 Quick Start Guide

Configuring Global Parameters
Cisco 1700 Router Software Configuration Guide
4-2
Table 4-1 illustrates the example configuration used in this chapter.
Figure 4-1 Leased Line Example Configuration
Configuring Global Parameters
Use this table to configure the router for some global parameters.
Step Task Router Prompt Command
1 Enter configuration mode.
Router#
configure terminal
2 Configure the router to show the date and time of all
debug messages.
This command is optional, but recommended if you use
debug commands to troubleshoot your configuration.
Router(config)#
service timestamps debug datetime msec
3 Configure the router to show the date and time of all
log messages.
This command is optional, but recommended if you use
the verification steps described in this guide. This
feature is enabled for all the example command output
shown in this guide.
Router(config)#
service timestamps log datetime msec
4 Configure the router to use subnet zero for interface
addresses and routing updates.
Router(config)#
ip subnet-zero
5 Disable the IP Domain Name System (DNS)-based
host name-to-address translation on the router.
Router(config)#
no ip domain-lookup
6 Enable IPX routing and configure the router with an
IPX address.
Router(config)#
ipx routing 0000.0caa.1111
Cisco
1700
Cisco
1700
Leased line
IPX network: AAAA
Network address:
IP:10.0.0.0
IPX:100
Network address:
IP:20.0.0.0
IPX:200
Remote site
Central site
Ethernet interface
IP address:
10.1.1.1
14486

Cisco 1700 Specifications

General

Brand	Cisco
Model	1700
Category	Network Router
Language	English