61
Cisco 3900 Series, Cisco 2900 Series, and Cisco 1900 Series Integrated Services Routers Generation 2 Software Configuration Guide
Configuring Ethernet Virtual Connection Bridge
Domain
Ethernet virtual connection (EVC) infrastructure is a Layer 2 platform-independent bridging
architecture that supports Ethernet services. This chapter provides procedures for configuring EVC
Bridge Domain (BD) and the features it supports on the Cisco Integrated Services Routers (ISR) G2.
• Configuring EVCs on Cisco ISR G2 Router, page 61
• Ethernet Data Plane Loopback, page 64
• Connectivity Fault Management (CFM) over EVC BD, page 68
• Support for Y.1731 Performance Monitoring for EVC BD, page 87
• Support for Switch Virtual Interfaces (SVI) on ISR G2 Metro Ethernet BD, page 90
• EVC Quality of Service (QoS), page 92
Configuring EVCs on Cisco ISR G2 Router
Configuring an EFP and a BD on the Cisco ISR G2 Router
Configuring a service instance on a Layer 2 port creates an EFP on which you can configure EVC
features.
Note • You cannot use the same VLAN ID for encapsulating on a Layer 3 sub-interface and an EFP (service
instance) on a WAN interface.
• If there is a sub-interface and service-instance both configured on a WAN interface for untagged
traffic, then the traffic will always go to the main interface and the service-instance with untagged
traffic will not work.
Perform this task to configure an EFP.
SUMMARY STEPS
Step 1 enable
Step 2 configure terminal
To Next Page
Loading...
Need help?
General
