Installing the Cisco 5520 Wireless Controller
This chapter describes how to install the Cisco 5520 Wireless Controller.
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with
standard practices for preventing accidents. Use the statement number provided at the end of each warning
to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
Warning
SAVE THESE INSTRUCTIONS
•
Unpacking and Inspecting the Controller, page 1
•
Preparing for Controller Installation, page 2
•
Installing the Controller in a Rack, page 3
•
Initial Controller Setup , page 8
•
System BIOS and Cisco Integrated Management Controller Firmware, page 9
Unpacking and Inspecting the Controller
When handling internal controller components, wear an ESD strap and handle modules by the carrier
edges only.
Caution
Retain the shipping container in case the controller requires shipping in the future.Tip
Cisco 5520 Wireless Controller Installation Guide
1
To Next Page
Need help?
General
