Installation Guide for Cisco IP Phone with Multiplatform Firmware
Wall Mount Your 8800 Series Phones
Wall Mount Your Phone
Wall Mount Your 8800 Series Phones
The following wall mount options are available:
• Cisco IP Phone 8800 Series Wall Mount Kit: A nonlockable wall mount kit available for the Cisco IP Phone
8800 Series. This wall kit applies to Cisco IP Phone 8811, 8841, 8851, and 8861. The PID is CP-8800-WMK=.
• Cisco IP Phone 8800 Series Wall Mount Kit with Single KEM: The kit is installed on the Cisco IP Phone 8851
and 8861 with one attached Cisco IP Phone 8800 Key Expansion Module. The PID is CP-8800-BEKEM-
WMK=.
Mount the wall bracket in the desired location.
1
Plug in the handset cable, then attach the phone
bracket to the rear panel of the phone.
2
447136
Components:
1. Four #8-18 x 1.25-inch Phillips-head screws
2. Four anchors
3. Two K30x8mm self-tapping screws
4. One phone bracket
5. One wall bracket
6. One 6-inch Ethernet cable
1 2 3
6
4
5
To Next Page
Loading...
Need help?
General
