1-25
Cisco 7200 Series Port Adapter Hardware Configuration Guidelines
OL-3875-11
Chapter 1 Cisco 7200 Series Port Adapter Installation Requirements
Error Messages
Error Messages
The system prompts you with error messages if your port adapter configuration exceeds the guidelines
in this document. Following are examples of the error messages:
• For a Cisco 7200 series router or Cisco 7200 VXR router that has an NPE-225, NPE-200, NPE-175,
NPE-150, or NPE-100 installed, the following error messages are displayed when the bandwidth
points exceed the system limit:
%C7200-3-PACONFIG:Exceeds 3 high speed port adapters
%C7200-3-PACONFIG:Exceeds 5 high/medium speed port adapters
%C7200-3-PACONFIG:Exceeds 800 aggregate port adapter bandwidth points
• For a Cisco 7200 VXR router that has an NPE-400, NPE-300, or NSE-1 installed, the following
error messages are displayed when the bandwidth points are exceeded on the buses:
%C7200-3-PACONFIG:Exceeds 600 bandwidth points for slots 0, 1, 3 & 5
%C7200-3-PACONFIG:Exceeds 600 bandwidth points for slots 2, 4 & 6
%C7200-3-PACONFIG:Exceeds 600 bandwidth points on both odd & even numbered slots
To Next Page
Loading...
Need help?
General
