• For MWI + speed dial + DTMF:
fnc=mwi+sd;ext=8000 ,4085283300#,123456#@domain;sub=group_vm@domain;vid=1;nme=Group;
For more information about the string syntax, see String Syntax for Voicemail PLK.
You can also configure this parameter in the phone configuration file (cfg.xml). The parameter is line-specific.
Enter a string in this format:
<Unit_1_Key_1_ ua="na">fnc=mwi+sd;ext=8000 ,4085283300#,123456#@domain;
sub=group_vm@domain;vid=1;nme=Group;</Unit_1_Key_1_>
Step 4 In the General section, add mwi or mwi;sd in the field Customizable PLK Options.
Parameter in the configuration file (cfg.xml):
<Customizable_PLK_Options ua="na">mwi;sd</Customizable_PLK_Options>
After the configuration, users can configure the corresponding features on the expansion module button.
Step 5 Click Submit All Changes.
Troubleshoot the Key Expansion Module
Procedure
Step 1 Open a CLI.
Step 2 Enter the following command to enter debug mode:
debugsh
Step 3 Enter ? to see all available commands and options.
Step 4 Use the applicable commands and options to find the desired information.
Step 5 To exit debug mode, press Ctrl-C.
Key Expansion Module Does Not Go Through the Normal Start Up Process
Problem
When you connect a key expansion module to a phone that is connected to a network port, the key expansion
module doesn't start up.
Cause
• Key expansion module type and the attached key expansion module don't match.
• The phone has more than one type of expansion module connected.
• Power over Ethernet (PoE) doesn't meet the required power-supply.
• Connected number of key expansion modules exceed maximum "Number of Units".
Cisco IP Phone Accessories
32
Cisco IP Phone Accessories
Troubleshoot the Key Expansion Module
To Next Page
Loading...
Need help?
General
