•
Web browser
•
Cisco.com user ID and password
Procedure
Step 1
To access the Cisco Bug Search, go to:
https://tools.cisco.com/bugsearch
Step 2
Log in with your Cisco.com user ID and password.
Step 3
To look for information about a specific problem, enter the bug ID number in the Search for field, then press
Enter.
Open Caveats
The following table lists severity 1, 2, and 3 defects that are open for the Cisco Unified IP Phones that use
Firmware Release 10.2(1).
For more information about an individual defect, you can access the online record for the defect by clicking
the Identifier or going to the URL that is shown. You must be a registered Cisco.com user to access this online
information.
Because defect status continually changes, the table reflects a snapshot of the defects that were open at the
time this report was compiled. For an updated view of open defects, access Bug Toolkit as described in Access
Cisco Bug Search, on page 7.
Table 2: Open Caveats for Firmware Release 10.2(1)
DescriptionIdentifier
Phone will DNS query (none).domain after resetCSCum62659
Display not be lit when On-Time comes with duration 00:00CSCum64968
Wrong CUCM IP address in REFER before and after re-registrationCSCum75600
Conference feature layer shall close while participant side park.CSCun19698
8861 doesn't make active scan in roamingCSCun24183
8861 may doesn't reply eap-request in roamingCSCun29272
Phone can answer a call from same phoneCSCun30024
Accessary(CDROM) Added window keeps pop up foreverCSCun38032
Wrong ReasonForOutOfService after IP address lostCSCun41637
Cisco IP Phone 8841, 8851, and 8861 Release Notes for Firmware Release 10.2(1)
8
Cisco IP Phone 8841, 8851, and 8861 Release Notes for Firmware Release 10.2(1)
Open Caveats
To Next Page
Loading...
Need help?
General
