CHAPTER
4-1
Cisco Integrated Services Router Hardware Installation Guide
OL-23125-02
4
Initial Configuration
This chapter provides instructions for initial configuration of the Cisco 819, 860, 880, 890 Series
Integrated Services Routers (ISRs), and contains the following sections:
• Cisco 810 Series, page 4-1
• Cisco 860, 880, 890 Series, page 4-2
Cisco 810 Series
Cisco 819 Series
This section provides instructions for initial configuration of the Cisco 819 ISRs. For the initial
configuration, we recommend using Cisco Configuration Professional Express. For instructions on how
to use Cisco Configuration Professional Express to configure the router, see Cisco Configuration
Professional Express User’s Guide.
You may also initially configure your router by using the Cisco IOS command-line interface (CLI) or by
using the setup command facility. To create the initial configuration, the setup command facility prompts
you for basic information about your router and network.
This section contains the following topics:
• Cisco IOS CLI, page 4-1
• Setup Command Facility, page 4-1
• Verifying the Initial Configuration, page 4-2
Cisco IOS CLI
To configure the initial router settings by using the Cisco IOS CLI, you must set up a console connection.
To configure the initial router settings using the Cisco IOS CLI, refer to the Cisco IOS CLI, page 4-2.
For instructions on how to set up a console connection, see the “Connecting a Terminal or PC to the
Console Port” section on page 3-16.
Setup Command Facility
For more information, refer to the “Setup Command Facility” section on page 4-4.
To Next Page
Loading...
Need help?
General
