You can only mount the chassis with the front panel oriented toward either the ceiling or the floor. Wall mounting in
other orientation is not supported.
What to do next
You can now install the cables and power cord, as described in Connect Cables, Turn on Power, and Verify
Connectivity, on page 6.
Rack Mount the ASA
Follow these steps to mount the ASA to a rack-mount shelf.
You mount only one ASA 5506H-X in the rack-mount shelf.
The dimensions of the ASA 5506H-X are 3.46 in. x 18.3 in. x 19.5 in. (8.79 cm x 46.48 cm x 49.52 cm). The
PID is asa5506h-rack-mnt=.
Note
Step 1 Place the ASA upside down on a large, stable work area. If you are installing two ASAs in the shelf, place the second
ASA beside the first, also upside down.
Step 2 Invert the sliding trays and position the ASA(s) on top of them such that the front of the device(s) and the front of the
tray are in the same direction.
Step 3 Adjust the position of the first ASA and the tray until the three mounting holes in the dimples in the bottom of the shelf
are aligned with the mounting holes in the bottom of the ASA.
Step 4 Tighten the captive tray screws into the shelf to lock it into place.
Figure 2: ASA 5506-X and ASA 5506W-X in the Rack-Mount Shelf
Mount and Connect
3
Mount and Connect
Rack Mount the ASA
To Next Page
Loading...
Need help?
General