Cisco ASR 1000 Series Replacing

%IOSXE-0-PLATFORM: R0/0: udev: harddisk: has been removed
What to do next
You have successfully removed the hard drive from the Cisco ASR 1001 Router.
Replacing the Hard Drive on the Cisco ASR 1001 Router
To insert or replace the hard drive on the Cisco ASR 1001 Router, follow this procedure:
SUMMARY STEPS
1. Carefully slide the hard drive unit into the slot on the front panel. The component is keyed for easy
insertion.
2. Tighten the fastener screw on the front panel by using a # 2 Phillips screwdriver or a flat head screwdriver.
3. Wait until the following console message is displayed:
4. Verify that the hard drive is working by running the following command:
DETAILED STEPS
Step 1 Carefully slide the hard drive unit into the slot on the front panel. The component is keyed for easy insertion.
Step 2 Tighten the fastener screw on the front panel by using a # 2 Phillips screwdriver or a flat head screwdriver.
Step 3 Wait until the following console message is displayed:
Example:
%IOSXE-0-PLATFORM: R0/0: udev: harddisk: file system ready” appears.
If this message is not displayed after a few minutes, run the following command:
request platform hardware filesystem harddisk: online
If the new hard drive system does not get mounted automatically, the disk may not be partitioned correctly.
Note
Step 4 Verify that the hard drive is working by running the following command:
dir harddisk
What to do next
You have successfully replaced the hard drive on the Cisco ASR 1001 Router.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
18
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Replacing the Hard Drive on the Cisco ASR 1001 Router

Cisco ASR 1000 Series Specifications

General

Brand	Cisco
Model	ASR 1000 Series
Category	Network Router
Language	English