If you are returning the Cisco ASR 1000 route processor to the factory, immediately place it in a static shielding
bag.
Note
What to do next
This completes the procedure for removing an installed Cisco ASR 1000 Series route processor from the
Cisco ASR 1006, Cisco ASR 1004, and Cisco ASR 1013 Router.
Replacing the Cisco ASR 1000 Series Route Processor in the Cisco ASR 1006,
Cisco ASR 1004, and Cisco ASR 1013 Routers
To replace the Cisco ASR 1000 Series route processor (RP1 or RP2) in the Cisco ASR 1006, Cisco ASR
1004, and Cisco ASR 1013 Routers, follow this procedure:
SUMMARY STEPS
1. Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
2. Remove the new Cisco ASR 1000 series route processor from its static shielding bag.
3. Using both hands, grasp the Cisco ASR 1000 Series route processor by its metal carrier edges and orient
the it so that its printed circuit board components are upward.
4. Align the left and right edges of the Cisco ASR 1000 Series route processor printed circuit board between
the route processor slot guides.
5. Gently slide the Cisco ASR 1000 Series route processor all the way into its chassis slot until you feel the
connectors seat with the router midplane.
6. Seat the route processor in the router midplane by tightening its captive installation screws with a number
2 Phillips or a 3/16-inch flat-blade screwdriver.
DETAILED STEPS
Step 1 Attach an ESD-preventive wrist strap between you and an unfinished chassis surface.
Step 2 Remove the new Cisco ASR 1000 series route processor from its static shielding bag.
Step 3 Using both hands, grasp the Cisco ASR 1000 Series route processor by its metal carrier edges and orient the it so that its
printed circuit board components are upward.
Handle the Cisco ASR 1000 Series route processor by the carrier edges and handle only; never touch the printed
circuit board components or connector pins.
Caution
Step 4 Align the left and right edges of the Cisco ASR 1000 Series route processor printed circuit board between the route
processor slot guides.
Step 5 Gently slide the Cisco ASR 1000 Series route processor all the way into its chassis slot until you feel the connectors seat
with the router midplane.
Step 6 Seat the route processor in the router midplane by tightening its captive installation screws with a number 2 Phillips or
a 3/16-inch flat-blade screwdriver.
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
3
Removing and Replacing FRUs from the Cisco ASR 1000 Series Routers
Replacing the Cisco ASR 1000 Series Route Processor in the Cisco ASR 1006, Cisco ASR 1004, and Cisco ASR 1013 Routers
To Next Page
Loading...
Need help?
General
