0/0/CPU0 A99-8X100GE-TR IOS XR RUN PWR,NSHUT,MON
0/2/CPU0 A99-12X100GE IOS XR RUN PWR,NSHUT,MON
0/3/CPU0 A99-8X100GE-TR IOS XR RUN PWR,NSHUT,MON
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
Before you begin:
• You must have console access to the router. Default console speed on RSP5 is set as 115200.
• The router must be running Cisco 64-bit IOS XR software release 6.5.15 or later version. If your router
is running a 32-bit IOS XR release, you will need to migrate to 64-bit XR release 6.5.15 or later. Refer
to Migration Guide for Cisco ASR 9000 Series Routers.
RSP5 is only supported with 64-bit IOS XR software releases.
Note
• The router must have two RSP4/S/L cards (active and standby) up and running. In this section, RSP
refers to RSP4/RSP4-S/RSP4-L in the system.
• First and second generation Cisco ASR 9000 Ethernet Line Cards must be removed from the chassis as
they are incompatible with RSP5.
Procedure
Step 1 Use the show redundancy summary command to verify that the RSP0 and RSP1 are in Ready State.
Example:
Router# show redundancy summary
Active/Primary Standby/Backup
-------------- --------------
0/RSP0/CPU0(A) 0/RSP1/CPU0(S) (Node Ready, NSR: Ready)
0/RSP1/CPU0(P) 0/RSP1/CPU0(B) (Proc Group Ready, NSR: Ready)
Step 2 Shutdown the standby RSP card (slot 1) using the admin hw-module shutdown location 0/RSP1 command.
Step 3 Remove the standby RSP card (slot 1). When RSP is removed, an alarm is generated indicating that the
redundancy is lost. Follow the procedure explained in the topic Removing and Replacing Cards from the
Chassis, on page 25.
Step 4 Insert RSP5 in slot 1 and allow RSP5 to bootup.
Step 5 Verify both the RSPs are in IOS XR RUN state using the show platform command.
Example:
Router#show platform
Node Type State Config state
--------------------------------------------------------------------------------
Replacing Cisco ASR 9000 Series Router Components
38
Replacing Cisco ASR 9000 Series Router Components
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
To Next Page
Loading...
Need help?
General
