Deployment
Optional Minimal Site Survey
16
Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points
78-17279-01
• Contact Cisco WLAN Solution for the Cisco 1000 series lightweight access point mounting brackets
and recommended telescoping stand screws.
• Use duct tape and/or cable ties to assemble the telescoping stands, Cisco 1000 series lightweight
access points, CAT-5 Ethernet cables, Ethernet power injectors, power inverter, external power
supply, battery packs, and/or extension cords as shown in the following figure.
Note Make sure you support the CAT-5 and power cables to remove harmful stress on the Cisco 1000 series
lightweight access point connectors.
Figure 7 Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies
•
Continue with “Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned
Location.”
Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned
Location
This section assumes that you have determined the Cisco 1000 series lightweight access point locations
as described in “Cisco 1000 Series Lightweight Access Point Placement.”
Refer to “Preparing Optional Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies” for
instructions on how to power the Cisco 1000 series lightweight access points at each planned location.
Caution If you are using AC extension cords, make sure you use duct tape to avoid creating trip hazards.
• Using the floor plans and/or maps from “Cisco 1000 Series Lightweight Access Point Placement
Guidelines,” place the Cisco 1000 series lightweight access point assemblies at or near the indicated
locations.
135689
AP
Power
converter
cable
110-220 VAC
extension cord
110-220 VAC
extension cord
External power
converter
B. Power converter/AC power
AP
CAT5 cable
Power injector
A. Power injector/AC power
To Next Page
Loading...
Need help?
General
