Cisco C9200L-24T-4X User Manual

Fan Modules Overview 47
Installation Guidelines 48
Installing a Fan Module 48
Finding the Fan Module Serial Number 49
Configuring the Switch 51
CHAPTER 6
Configuring the Switch Using the Web User Interface 51
Setting up the Switch 51
Connecting to the Switch 51
Creating User Accounts 52
Choosing Setup Options 53
Configuring Basic Device Settings 53
Configuring Your Device Based on a Site Profile 54
Configuring Switch Wide Settings 59
Configuring VLAN Settings 59
Configure STP Settings 60
Configuring DHCP, NTP, DNS and SNMP Settings 60
Configuring Port Settings 61
Configuring the Switch Using the CLI 62
Accessing the CLI Through the Console Port 62
Connecting the RJ-45 Console Port 63
Connecting the USB Console Port 63
Installing the Cisco Microsoft Windows USB Device Driver 64
Installing the Cisco Microsoft Windows XP USB Driver 64
Installing the Cisco Microsoft Windows 2000 USB Driver 65
Installing the Cisco Microsoft Windows Vista and Windows 7 USB Driver 65
Uninstalling the Cisco Microsoft Windows USB Driver 65
Uninstalling the Cisco Microsoft Windows XP and 2000 USB Driver 65
Uninstalling the Cisco Microsoft Windows Vista and Windows 7 USB Driver 66
Technical Specifications 69
APPENDIX A
Environmental and Physical Specifications 69
Specifications for the Power Supplies and Fans 72
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
v
Contents

Cisco C9200L-24T-4X Specifications

General

Model	C9200L-24T-4X
Device Type	Switch
Enclosure Type	Rack-mountable
Subtype	Gigabit Ethernet
Switching Capacity	128 Gbps
Forwarding Rate	95.23 Mpps
DRAM	4 GB
Flash Memory	4 GB
Power Device	Internal power supply
Ports	24 x 10/100/1000
Uplink Interfaces	4 x 10 Gigabit SFP+
MAC Address Table Size	16, 000 entries
Jumbo Frame Support	9198 bytes
Routing Protocol	OSPF, BGP, EIGRP, RIP
Remote Management Protocol	SNMP 1, SNMP 2, SNMP 3, RMON, SSH, Telnet, HTTP, HTTPS
Features	VLAN support, Quality of Service (QoS), ACL support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.3ab, IEEE 802.3ae
Voltage Required	AC 120/230 V (50 - 60 Hz)
Stacking	Stackable
Operating Temperature	32 to 104°F (0 to 40°C)