Cisco Catalyst IE 3 00 Series User Manual

When the switch is installed in an industrial enclosure, the temperature within the enclosure is greater than
normal room temperature outside the enclosure.
Ensure temperatures inside the enclosure conform to device specifications detailed in the Data Sheet.
Caution
• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting
fixtures.
Installing or Removing the Flash Memory Card (Optional)
Optionally, you can execute the sync command to copy Flash to SDFlash: and make SDFlash: the primary
storage, then remove the SD card.
It is strongly recommended that you use the SD card to boot or store the config for future easy replacement,
in case of a hardware failure.
To install or replace the flash memory card, follow these steps:
1. On the front of the switch, locate the door that protects the flash memory card slot. Loosen the captive
screw at the top of the door using a Phillips screwdriver to open the door.
Figure 1: Installing the Flash Memory Card in the Switch
Switch Installation
5
Switch Installation
Installing or Removing the Flash Memory Card (Optional)

Cisco Catalyst IE 3 00 Series Specifications

General

Brand	Cisco
Model	Catalyst IE 3 00 Series
Category	Switch
Language	English