2-44
Cisco CRS-1 Series Carrier Routing System XML API Guide
OL-4596-01
Chapter 2 Cisco CRS-1 Series XML Router Configuration and Management
Additional Cisco CRS-1 Series Router Configuration and Management Options Using XML
<GetConfigurationHistory> operation used with a RollbackOnly value of “false” corresponds to the
CLI command show configuration history. When the RollbackOnly attribute is specified as “true”,
the operation corresponds to the CLI command show rollback-points.
The following example shows a request to list the information associated with the previous three
commits. This request corresponds to the CLI command show configuration history 3.
Sample XML Request to List Configuration History Information for the Previous Three Commits
<?xml version="1.0" encoding="UTF-8"?>
<Request MajorVersion="1" MinorVersion="0">
<GetConfigurationHistory Maximum=”3”/>
</Request>
Sample XML Response from the Cisco CRS-1 Series Router
<?xml version="1.0" encoding="UTF-8"?>
<Response MajorVersion="1" MinorVersion="0">
<GetConfigurationHistory Maximum=”3”>
<CommitEntry>
<CommitID>1000000075</CommitID>
<Label>BGPUpdate1</Label>
<UserID>cisco</UserID>
<Line>line0</Line>
<ClientName>XMLDemo</ClientName>
<Timestamp>Wed June 18 19:16:18 2003</Timestamp>
<Comment>BGP config update</Comment>
</CommitEntry>
<CommitEntry>
<CommitID>1000000074</CommitID>
<Label xsi:nill=”true”>
<UserID>unknown</UserID>
<Line>con0_0_0</Line>
<ClientName>CLI</ClientName>
<Timestamp>Wed June 18 03:08:07 2003</Timestamp>
<Comment xsi:nill=”true”>
</CommitEntry>
<CommitEntry>
<CommitID>1000000073</CommitID>
<Label>MyCDPUpdate</Label>
<UserID>nchomsky</UserID>
<Line>line1</Line>
<ClientName>XMLDemo</ClientName>
<Timestamp>Tue June 17 11:07:55 2003</Timestamp>
<Comment>My CDP config update</Comment>
</ComitEntry>
</GetConfigurationHistory>
</Response>
Getting Configuration Session Information
The client application uses the <GetConfigurationSessions> operation to get the list of all users currently
configuring the Cisco CRS-1 Series router. In the case where the configuration is locked, the list will
identify the user holding the lock.