Installing the Cisco ISA 3000 Industrial Security
Appliance
This chapter describes the equipment and the procedures for successfully installing the Cisco ISA 3000.
• Items Shipped with your Cisco ISA 3000, on page 1
• Additional Items, on page 1
• Ethernet Devices, on page 2
• Installing the Cisco ISA 3000, on page 2
Items Shipped with your Cisco ISA 3000
Unpack the box and verify that all items listed on the invoice were shipped with the Cisco ISA 3000.
The following items are shipped with your device:
• Product Document Of Compliance (PDOC) Part Number 78-100733-01
• Two Power Connectors
• Alarm Connector
Additional Items
The following items are not shipped with the router but are required for installation:
• ESD-preventive cord and wrist strap.
• Wire crimper for chassis grounding.
• Wire for connecting the chassis to an earth ground.
• AWG 14 (2 mm²) or larger wire for NEC-compliant chassis grounding.
• Ethernet cables for connecting devices to the Gigabit Ethernet ports.
• Fiber optic cables and SFP transceivers for connecting to fiber LAN ports.
• Ratcheting torque flathead screwdriver that exerts up to 15 in-lb (1.69 N-m) of pressure.
Installing the Cisco ISA 3000 Industrial Security Appliance
1
To Next Page
Need help?
General
