Cisco Router Cisco 3600 Configuration Guide

Linking PBX Users with E&M Trunk Lines
Configuring Voice over IP for the Cisco 3600 Series VC-43
Linking PBX Users with E&M Trunk Lines
The following example shows how to configure Voice over IP to link PBX users with E&M trunk
lines.
In this example, a company wants to connect two offices: one in San Jose, California and the other
in Salt Lake City, Utah. Each office has an internal telephone network using PBX, connected to the
voice network by an E&M interface. Both the Salt Lake City and the San Jose offices are using E&M
Port Type II, with four-wire operation and ImmediateStart signaling. Each E&M interface connects
to the router using two voice interface connections. Users in San Jose dial “8-569” and then the
extension number to reach a destination in Salt Lake City. Users in Salt Lake City dial “4-527” and
then the extension number to reach a destination in San Jose.
Figure 13 illustrates the topology of this connection example.
Figure 13 Linking PBX Users with E&M Trunk Lines Example
Note This example assumes that the company already has established a working IP connection
between its two remote offices.
Configuration for Router SJ
hostname sanjose
!Configure pots dial peer 1
dial-peer voice 1 pots
destination-pattern 555....
port 1/0/0
!Configure pots dial peer 2
dial-peer voice 2 pots
destination-pattern 555....
port 1/0/1
!Configure voip dial peer 3
dial-peer voice 3 voip
destination-pattern 119....
session target ipv4:172.16.65.182
!Configure the E&M interface
voice-port 1/0/0
signal immediate
operation 4-wire
type 2
S6616
Dial peer
1 POTS
Router SJ
San Jose
(408)
Salt Lake City
(801)
Router SLC
Dial peer
2 POTS
PBX PBX
172.16.1.123
172.16.65.182
Voice port
1/0/0
Dial peer
1 POTS
Voice port
1/0/0
Voice port
1/0/1
Dial peer
2 POTS
Voice port
1/0/1
IP cloud

Cisco Router Cisco 3600 Specifications

General

Brand	Cisco
Model	Router Cisco 3600
Category	Network Router
Language	English