Cisco RV160 User Manual

6 Cisco RV160 Router Quick Start Guide
Kensington Lock Slot — Lock slot on the right side to secure the device
physically, using the Kensington lock-down equipment.
Connecting the Equipment
Connect a configuration terminal (PC) to the device by using a LAN port.
The terminal must be in the same wired subnetwork as the device to
perform the initial configuration. As part of the initial configuration, the
device can be configured to allow remote management.
To connect a computer to the device:
STEP 1 Power off all equipment, including the cable or DSL modem, the
computer, and this device.
STEP 2 Use an Ethernet cable to connect your cable or DSL modem to the
WAN port on this device.
STEP 3 Connect another Ethernet cable from one of the LAN (Ethernet)
ports to the Ethernet port on the computer.
STEP 4 Power on the WAN device and wait until the connection is active.
STEP 5 Connect the power adapter to the 12VDC port of this device.
CAUTION Use only the power adapter that is supplied with the device.
Using a different power adapter could damage the device or
cause the USB dongles to fail.
The power switch is on by default. The power light on the front
panel is solid green when the power adapter is connected
properly and the device is finished booting.
STEP 6 Plug the other end of the adapter into an electrical outlet. Use the
plug (supplied) specific to your country.
STEP 7 Continue with the instructions in the Using the Setup Wizard to
configure the device.
Using the Setup Wizard
The Setup Wizard and Device Manager are supported on Microsoft
Internet Explorer, Mozilla Firefox, Apple Safari, and Google Chrome.
3
444

Cisco RV160 Specifications

General

DSL WAN	-
Ethernet WAN	Yes
Throughput	0.6 Gbit/s
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.1x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
Combo SFP ports quantity	1
Ethernet LAN (RJ-45) ports	4
Mobile network generation	Not supported
Security algorithms	IPSec
VPN tunnels quantity	10
Routing protocols	RIP-1, RIP-2, RIPng
Product color	Black, Grey
Country of origin	China
Power source type	DC
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	10 - 85 %
Processor cores	2
Quantity per pack	1 pc(s)
Harmonized System (HS) code	85176990
Package depth	288.798 mm
Package width	249.936 mm
Package height	106.934 mm
Package weight	1224.7 g

Weight and Dimensions

Depth	199.898 mm
Width	150.114 mm
Height	29.972 mm
Weight	589.95 g