D-8
Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide
OL-13478-03
Appendix D Connecting DC Power
Connecting DC Power to a CDE400
Figure D-7 CDE400 Rear Panel
Connect DC power to the CDE400 by performing the following steps:
Caution Make sure the DC power wires are not attached to the DC power source until all the ground wires are
connected on the CDE.
Step 1 Insert one blue DC power cable connector into the blue port on each PM, making sure it is completely
seated.
1 PM 4 7 PM ground
2 PM 3 8 –48 VDC
3 Building ground wire 9 PM ground stud 1
4 PM 2 10 Building ground stud
5 PM 1 11 PM ground stud 2
6 +Return
280161
1245
9 10 11
3
7
68
To Next Page
Loading...
Need help?
General
