Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 3
Cisco SR2024 24-Port 10/100/1000 Gigabit Switch
Cisco Small Business Unmanaged Switches
Wire-Speed Switching and Cisco Reliability in a 24-Port Gigabit Switch
Highlights
●
Connect up to 24 devices at 10/100/1000 Mbps with half- or full-duplex switched ports and
two mini-GBIC expansion ports
●
High-speed conectivity to support high-bandwidth applications
●
Works right out of the box with no software to configure
●
Rack-mount installation
Figure 1. Cisco SR2024 24-Port 10/100/1000 Gigabit Switch
Product Overview
The Cisco
®
SR2024 24-Port 10/100/1000 Gigabit Switch (Figure 1) provides nonblocking, wire-
speed switching for your 10-, 100-, and 1000-Mb network clients. Use this switch to replace your
current workgroup hub or switch, and you can upgrade your high-requirement workstations to full
Gigabit speeds as necessary, while continuing to service other clients at their current speeds. Or
build your network from the ground up, with appropriate link speeds for each user's requirements.
Either way, it's perfect for graphics, multimedia, and other applications that have to move large
files across the network quickly. And when you need to expand your network even further, the two
mini Gigabit Interface Converter (mini-GBIC) ports let you add fiber-optic capability easily and cost-
effectively.
With the Cisco SR2024, you can connect your existing 10/100 Ethernet network to a Gigabit server
backbone without any additional equipment. All ports have automatic medium dependent interface
(MDI) and MDI crossover (MDI-X) cable detection, so you don't have to worry about the cable type.
Each port independently and automatically negotiates for best speed and determines whether to
run in half- or full-duplex mode. Address Learning and Aging are supported, as well as 802.3x flow
control with head-of-line blocking prevention to keep your high-speed clients from bogging down in
lower-speed traffic. Fast store-and-forward switching prevents damaged packets from being
passed on to the network.
To Next Page
Need help?
General
