Cisco UCS B200 M3 Installation Manual

d) Replace the server in the chassis and power on the blade by pressing the Power button.
Figure 10: Location of the Motherboard CMOS Battery
CPU and Heatsink Replacement
Special Information For Upgrades to Intel E5-2600 v2 Series CPUs
You must upgrade your server firmware to the required minimum level before you upgrade to Intel E5-2600
v2 Series CPUs. Older firmware versions cannot recognize the new CPUs and this results in a non-bootable
server.
Caution
The minimum software and firmware versions required for the server to support Intel E5-2600 v2 Series CPUs are as follows:
Table 2: Minimum Requirements For Intel E5-2600 v2 Series CPUs
Minimum VersionSoftware or Firmware
14

Cisco UCS B200 M3 Specifications

General

System bus rate	8 GT/s
Processor family	Intel
Processor socket	LGA 2011 (Socket R)
Intel Xeon series	E5-2600
Motherboard chipset	Intel C600
Compatible processor series	Intel® Xeon®
Number of processors supported	2
ECC	Yes
Memory form factor	240-pin DIMM
Number of DIMM slots	24
Supported memory types	DDR3-SDRAM
Maximum internal memory	768 GB
RAID levels	0, 1
Storage drive sizes supported	2.5 \
Supported storage drive interfaces	Serial Attached SCSI (SAS), Serial ATA III
USB 2.0 ports quantity	0
On-board graphics card model	Matrox G200
Chassis type	-
Product color	Silver
Storage temperature (T-T)	-40 - 65 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	5 - 93 %
Harmonized System (HS) code	84714100

Weight and Dimensions

Depth	620 mm
Width	203 mm
Height	50 mm
Weight	4360 g