Cisco VCS Series User Manual

Using the Cisco VCS
Refer to the Cisco VCS Administrator Guide, deployment guides and release notes (available for
download from www.tandberg.com) or the online help for complete information on configuring these
and all other options available on your Cisco VCS.
Using the web interface
To use the web interface:
1. Open a browser window and in the address line type either:
l the IP address of the Cisco VCS
l the FQDN of the Cisco VCS
The Login page will appear.
2. Select Administrator Login.
3. Enter a valid administrator username and password and select Login.
You will be presented with the Overview page.
Refer to the online help or the Cisco VCS Administrator Guide for further information on the
configuration options available for each page of the Cisco VCS web interface.
Using the Command Line Interface (CLI)
The command line interface is available over SSH and through the serial port by default. Access using
Telnet can also be enabled.
To use the command line interface:
1. Start a SSH or Telnet session.
2. Enter the IP address or FQDN of the Cisco VCS.
3.
Login with a username of admin and your system password.
You will see a welcome message.
For a full list of CLI commands available on the Cisco VCS, see the Command Reference appendix of
the Cisco VCS Administrator Guide.
VCS Getting Started Guide Page 10 of 12

Cisco VCS Series Specifications

General

Brand	Cisco
Model	VCS Series
Category	Server
Language	English