Required tools and equipment for installation
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
You need the following tools and equipment to install and upgrade the Voice Gateway and its components:
• Standard flat-blade screwdriver as required for attaching brackets to rack or wall.
• Phillips screwdriver for attaching the brackets to the Voice Gateway.
• Mounting brackets and screws for the 24-inch rack, if required.
• Four telco machine screws, for installing the chassis in a rack (use the screw size required by the rack).
• Screws and anchors for wall-mounting, if required:
• Eight wood screws or other fasteners, for installing the chassis on a wall.
• An additional starter screw can be used to facilitate wall-mounting.
• An ESD-preventive wrist strap
• In addition, you might also need the following external equipment:
• A Console terminal or PC with terminal emulation software
• A PC running terminal emulation software for administrative access
• Modem for remote access.
• Analog voice RJ-11 cables
• Ethernet switch
• A modem for remote configuration.
Site Log
We recommend that you maintain a Site Log to record all actions relevant to the system. Site Log entries
might include the following:
• Installation—Print a copy of the Installation Checklist and insert it into the Site Log.
• Upgrades and maintenance—Use the Site Log to record ongoing maintenance and expansion history.
Update the Site Log to reflect the following:
• Configuration changes
• Maintenance schedules, requirements, and procedures performed
• Comments, notes, and problems
• Changes and updates to Cisco IOS software
Cisco VG400 Voice Gateway Hardware Installation Guide
15
Planning Your Installation
Required tools and equipment for installation
To Next Page
Loading...
Need help?
General
