CHAPTER 3
Installing the Cisco VG400 Voice Gateway
The following chapter describes how to install and connect a Cisco VG400 Voice Gateway. The following
sections provide the installation procedures in detail:
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Danger
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Danger
• Safety Recommendations, on page 17
• Unpacking and Inspection, on page 19
• Install the Cisco VG400 Voice Gateway, on page 19
• Connect to Power Supply, on page 25
• Power-On Procedure, on page 25
Safety Recommendations
Before you begin the installation, read the following safety warnings and recommendations. The following
information is included to alert you to safety recommendations and best practices when working with this
equipment.
Maintaining Safety with Electricity
Follow these guidelines when working on equipment powered by electricity.
Avoid using or servicing any equipment that has outdoor connections during an electrical storm. There may
be a risk of electric shock from lightning. Statement 1088.
Danger
Cisco VG400 Voice Gateway Hardware Installation Guide
17
To Next Page
Loading...
Need help?
General
