[SMB-20E]
― 5
UNPACKAGING
1
HOWTOASSEMBLE
ANDINSTALL
２
INTRODUCTION
Thank you for choosing our Pick&Place unit.
This product is a composite unit that uses two cams for the horizontal and vertical directions to
output horizontal and vertical motions.
This manual shows precautions and service/inspection items below. Please
carefuly read this manual before use or maintenance.
1. UNPACKING
Check that the product is as ordered
1) Model No.
2) Check for damage caused during transportation.
If any failure such as a missing screw, oil leak, or bent shaft is found, contact the
branch, sales office, or agency from which the product was purchased.
2. HOWTOASSEMBLEANDINSTALL
1) Install the product as the attitude according to the specifications.
2) Install the product so that it can be easily inspected, disassembled, and
assembled and grease can be added..
3) Bolt a jig, if necessary, onto the output arm or output table in a position close to
the center of the traveling section of the output axis. If this operation is done in
the retention area of the output axis, force may be applied to the internal cam
follower, resulting in damage to the P & P unit.
4) Do not apply an impact to the output arm or output table with a hammer or
another tool when mounting a jig on it.
Such an impact may cause damage to the P & P unit or lower accuracy.
5) Key way are often used to secure the dial plate,
coupling, gear, sprocket, pulley, cam, boss, or
another part to the shaft. A chattering key way
always leads to shock or vibration The use of
standard key, JIS B 1301-1996 is recommended.
The methods fixing certainly should be conducted
for fixing important section not only using key but
using split model and friction fasteners, etc.
CAUTION:
！
Theproductmustbeassembledbyapersonwithabasicknowledge
abouttheassembly.
Key
Boss
Shaft
(split model)
To Next Page
Loading...
Need help?
General
