Arion 500-600 10.07 –
GB
A.9
Use of axle stands
Hydraulics
Transmission oil: Transmision oil is used as hydraulic fluid for the linkage and external services.
Oil escaping from a pipe under pressure can have sufficient force to penetrate the skin. Should an injury be caused by oil under
pressure, see a doctor immediately. Serious infection can occur if the wound is not treated immediately.
Consequently, always use a piece of wood or cardboard to find a leak on a pipe under pressure: never use your hand!
As a general rule: Make sure the unions are tight and the pipes in good condition before putting the system under pressure.
Never loosen a union when the circuit is under pressure.
For any repairs to the hydraulic system, stop the engine and lower the implement to the ground.
Let the oil cool down before working on the system, to prevent any risk of getting burnt when the oil flows. Maintenance -
greasing: Always stop the engine.
The hydraulic circuit of the frontal loader is designed to bear a maximum service pressure of
200
bar. Never modify the
connection of hydraulic hoses.
If the tractor is to be placed on axle stands, always work on a
flat, horizontal, hard surface.
Check the axle stands are suitable for the load. For this
operation, check the tractor's front and rear weights in chapter
K
.
4
-4-wheel drive tractor
If the rear axle is on stands, do not start the engine.
Risk of the tractor moving if the brakes are activated (foot brake
or hand brake).
If the engine has to be started, the front axle must also be
supported on axle stands.
001hsn31
To Next Page
Loading...
Need help?
General
