Shear Bar Corn Cracker
25 26
Shear Bar Adjustment
The shear bar can be adjusted automatically from
the comfort of the cab using CEBIS. The shear bar should
be readjusted after each sharpening and where possible
between sharpening intervals.
The crop coming from the chopper unit is crushed between
the Corn Cracker rollers and conveyed to the accelerator.
The purpose of the cracker is to open each kernel of maize in
order to free its starch to allow its starch to be free for digestion.
When the Corn Cracker is not in use, it should be completely
removed from the machine because at stand still the high
performance bearings might be damaged by the vibrations
in the machine.
Multi Crop Cracker Variants (MCC)
Please refer to the operators manual Section 9.12.9, for
full instructions.
Recommendations:
The condition and the adjustment of the shear bar are essential
to obtain optimum chopping quality, maximum efciency and long
service lives of knives and shear bar.
1. Readjust the shear bar after every sharpening process.
2. If needed, the shear bar should be readjusted without knife
sharpening, ie. if clearance too great.
3. Adjust the shear bar as close as possible to the knives, for
optimum chop quality. The knives must not touch the shear bar,
otherwise wear increases. A feeler gauge can be used to monitor
the gap.
4. To assess the wear condition of the shear bar, the rear side
must be inspected. (The rear of the shear bar must be able to sit
straight on the knife).
> The cutting edges of PREMIUM LINE shear bars have a longer
service life and therefore improve chopping quality and
service life.
Shear Bar Adjustment
When the shear bar is worn or cannot be readjusted any further,
it must be turned around or replaced.
Type Machine
MCC - M - 80/100 teeth
JAGUAR
830-870
6 - groove
JAGUAR
870-880
7 - groove
MCC “L” 125/125 teeth
MCC - M - 125/125 teeth (whole crop)
MCC MAX 120/130
MCC - M - 100/100 teeth
MCC “L” 150/150 teeth
MCC “L” 100/125 teeth
Shredlage 110/145
Power Band Belt
To Next Page
Loading...
Need help?
General
