English
8
CMD8
System Setup
SCRN SVR: ON/OFF
Rotate the [UP/DOWN] knob to choose
SCRN SVR (screen saver) ON or OFF.
SCROLL: ON/OFF
For track information that is longer than the
display panel:
When SCOLL is ON, the LCD will scroll the
ID3 TAG information across the display, e.g.:
TRACK->FOLDER->FILE->ALBUM->TITLE-
>ARTIST->TRACK->...
When SCROLL is OFF, the LCD will display
one of the ID3 TAG information, the default
is TRACK, but user can adjust it to other
ID3 TAG information by pressing [DISPLAY]
button.
REAR/S-W
Rotate the [UP/DOWN] knob to choose
REAR or S-WOOFER (SUB-WOOFER).
SW PHASE
Rotate the [UP/DOWN] knob to choose
S U B W O O F E R p h a s e REV E R S E or
NORMAL.
Pandora: ON/OFF
Select OFF if the Pandora application has
not been installed on your iPod touch or
iPhone.
DIMMER: ON/OFF
Rotate the [UP/DOWN] knob to choose
DIMMER ON or OFF.
• ON: LCD dimmer is active when small
light of vehicle is turned ON.
• OFF: LCD always maximum brightness
regardless of the vehicle small light.
CONTRAST
You can adjust the display contrast to match
the angle of installation of the unit.
* The factory default setting is “9”.
(Adjustment level: 1 to 10)
Rotate the [UP/DOWN] knob to adjust the
contrast.
To change adjustment setting
1. Press the [ADJUST] button to switch to
the adjustment selection display.
2. Press the [ ] or [ ] button to select the
“item name”.
CLOCK, DX/LO, SCRN SVR, SCROLL,
REAR / S-W, SW PHAS E , P andora ,
DIMMER, CONTRAST, BEEP, 12/24H,
RESET
3. Rotate the [UP/DOWN] knob to select the
“desired setting value”.
* In the case of display blinking “ENT”, you
can press the [ENTER] button to adjust
the setting value.
4. After completing settings, press the
[ADJUST] or [RETURN] button to return to
the previous mode.
CLOCK
1. Press the [ENTER] button.
2. Press the [
] or [ ] button to select the
hour or the minute.
3. Rotate the [UP/DOWN] knob to set the
correct time.
* The clock is displayed in 12-hour format
by default.
4. Press the [ENTER] button to store the time
into memory.
Note:
• You cannot set t he cl ock wh en it is
displayedwith onlytheignitionon.If you
drainor removetheboat’sbatteryortake
out this unit, the clock is reset. While
setting the clock, if another button or
operationisselected, the clocksetmode
iscanceled.
DX/LO (RADIO mode)
Rotate the [UP/DOWN] knob to choose radio
local or distant at RADIO mode.
• LO: Only stations with strong signal can
be received.
• DX: Stations with strong and weak signals
can be received.
System Setup
Press the [AUDIO] button to enter sound effect
setting mode. First press shows current BEAT
EQ setting. Rotate the [UP/DOWN] knob to
changes BEAT EQ in this order:
OFF -> B-BOOST -> IMPACT -> EXCITE ->
CUSTOM
Rotate the [UP/DOWN] knob to changes
CUSTOM, and press the [ENTER] button, the
press [ ] or [ ] button to select it including:
BASS-G -> BASS-F -> BASS-Q -> MID-G ->
MID-F -> MID-Q -> TREBLE-G -> TREBLE-F
-> TREBLE-Q, rotate the [UP/DOWN] knob to
select a value.
BASS-G / MID-G / TREBLE-G: (-7)- (+7)
BASS-F: 50 / 100 / 200
BASS-Q: 0.7 / 1.0 / 1.4 / 2.0
MID-F: 500 /1K / 2K
MID-Q: 0.7 / 1.0 / 1.4 / 2.0
TREBLE-F: 5k / 10k / 15k
TREBLE-Q: 0.7 / 1.0 / 1.4 / 2.0
Audio Setup
Press the [AUDIO] button, then press [ ] or
[ ] button to select USER preset including:
BALANCE -> FADER -> M-B EX -> HPF
(high pass lter) -> LPF (low pass lter) ->
SUBW VOL (Subwoofer Volume), rotate the
[UP/DOWN] knob to select a value.
BALANCE: LEFT 1-7 -> CENTER -> RIGHT
1-7
FADER: FRONT 1-7 -> CENTER -> REAR
1-7
M-BEX: ON / OFF
HPF: THROUGH / 60 / 90 / 120
LPF: THROUGH / 60 / 90 / 120
SUBW VOL: (-6) - (+6)
BEEP: ON/OFF
Rotate the [UP/DOWN] knob to choose button
beep sound ON or OFF.
12/24H
Rotate the [UP/DOWN] knob to choose time
format: 12 HOURS or 24 HOURS.
RESET
Long press [ ENTER ] button. Settings will
be set to the default value.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
