11
English
NX302E
Installation Guide
Before Starting
Cautions On Installation
1. Prepare all articles necessary for installing
the main unit before starting.
2. Install the unit within 30° of the horizontal
plane.
3. If you have to do any modication on the
car body, such as drilling holes, consult
your car dealer beforehand.
4. Use the included screws for installation.
Using other screws can cause damage.
Package Contents
Source unit ................................................1
Wire connector ..........................................1
GPS antenna .............................................1
CLAMP for GPS antenna’s cable ..............3
DOUBLE FACE TAPE for GPS Antenna...1
Cleaning cloth ............................................1
Warranty Card ...........................................1
Quick Start Guide ......................................1
Car battery
1. This set is exclusively for use in cars with a
negative ground, 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery “
” terminal
before starting. This is to prevent short circuits
during installation.
Max. 30°
Chassis
Damage
Max. 6 mm (M5 screw)
Owner’s manual (CD-R) ............................1
Electro tap .................................................2
Flush mount bolts(M5x6) ...........................8
Hexagon Head Screw(M5x6) ....................8
Rear Stud Bolt ...........................................1
Rubber Parts .............................................1
AV cable ....................................................1