EasyManuals Logo
Home>Clarion>Amplifier>XN3210

Clarion XN3210 User Manual

Clarion XN3210
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
XN3210/XN3410 3
English
Owner’s Manual
INTRODUCTION
The Clarion XN3210 is a full-featured, two-channel amplifier incorporating the
following features:
Specially coated circuit boards that resists mold, mildew and moisture damage.
Pulse-Width Modulated (PWM) MOSFET power supply for maximum
performance with minimal distortion.
Remote turn-on with "soft start" muting to prevent turn-on "thump".
Variable high-pass/low-pass electronic crossover with a 12dB per octave
slope (adjustable range: 55Hz to 5.5kHz).
Variable bass boost circuit to reinforce low frequency signals that may be lost
due to subwoofer enclosure design.
Adjustable input level controls with ground loop isolation to minimize noise
and distortion.
2-ohm stereo stable, 4-ohm mono stable.
Chrome-plated power, speaker and RCA connections.
Speaker level input.
Low profile construction with aluminum heat sink for efficient heat dissipation.
The Clarion XN3410 is a full featured, four-channel amplifier adding the following
feature:
Advanced circuitry design featuring bridgeable and mixed mode operation for
use in various system configurations including 4, 3, or 2 channel systems.
ABOUT THE MANUAL AND WARRANTY
This manual describes the basic requirements to install the Clarion XN3210 and
XN3410 amplifiers. The installation of this amplifier can be quite complex to install.
If you do not posses the necessary knowledge and tools to perform this installation,
please contact your local Clarion Marine Audio dealer.
Keep all instructions and sales receipt for future reference and warranty information.
Warranty information can be found on page 19 of this manual.
TABLE OF CONTENTS
Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Input Connections and Audio Controls . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Connections for Power and Speakers . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Mounting Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Wiring Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
XN3410 Wiring and Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
XN3210 Wiring and Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Setting the Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Setting the Crossover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Setting the Subwoofer Bass Boost . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Final System Check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Product Specs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
XN3210_3410 manual_060410 R2.ind3 3 9/3/2010 8:49:17 AM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarion XN3210 and is the answer not in the manual?

Clarion XN3210 Specifications

XN3410

Audio Specifications IconAudio Specifications
frequency response20Hz ~ 20kHz
signal to noise ratio97db
total harmonic distortion (THD).10% all channels driven
Input Sensitivity IconInput Sensitivity
low level input sensitivity200mV ~ 6.0V

XN3210

Audio Specifications IconAudio Specifications
frequency response20Hz ~ 20kHz
signal to noise ratio95db
total harmonic distortion (THD).10% all channels driven
Input Sensitivity IconInput Sensitivity
low level input sensitivity200mV ~ 6.0V
speaker level input sensitivity500mV ~ 13V
Power Output IconPower Output
max power output360W (180W x2)
continuous power output180W (90W x2) @ 1.0% THD
2-ohm stereo output150W x 2 @ 1.0% THD
bridged power250W x 1 @ 1.0% THD
Power Consumption IconPower Consumption
current consumption29A @ 382 Watts
Weight and Dimensions IconWeight and Dimensions
dimensions2-9/16" H x 9" W x 13" L

Related product manuals