Clover b9a User Manual

- 7 -
assembly.
The dual float valve’
s
packing is defective.
Replace the dual float valves packing.
The cold water piping is defective.
Properly connect and replace the cold
water piping.
NON SPILL SYSTEM
A. Water flow is slow
from all faucet.
User has taken a large draw or series of
draws and reservoir has not yet refilled.
( Non Spill System only )
Wait until the cold water tank is filled with
water after a large draw due to
inherent restriction of the Non Spill System.
Air filter is wet.
Allow filter to dry. Airflow through the filter
will gradually return to normal as the filters
dries.
B. An ex
cessive
quantity of water
accumulates in the
housing.
The housing is designed to hold a small
amount of water that may seep through the
cap at the bottle neck.
If problem happens on a high percentage
of cooler, there may be a defect in a cap.
Contact the cap manufacturer.
8. WIRING DIAGRAM

Clover b9a Specifications

General

Brand	Clover
Model	b9a
Category	Water Dispenser
Language	English